What is the Test Method of

New System Constant Temperature Humidity Chamber

Constant temperature and humidity chambers are an important test equipment used in various industries. It is important to have a reliable test method to ensure the accuracy of the testing results. This article will discuss the test method of the new system constant temperature and humidity chamber.

Before discussing the testing procedures, we need to understand the requirements required for environmental chamber testing.

Firstly, the chamber should be tested for performance. This involves testing the temperature uniformity and accuracy of the chamber. It should also be tested for its capacity to maintain constant temperature and humidity levels. The chamber should also be tested for its capacity to recover from rapid changes in temperature and humidity.

Secondly, the chamber should be tested for its accuracy. This involves testing the temperature and humidity at different points in the chamber. The accuracy should be within the specified range.

Thirdly, the chamber should be tested for its response time. This involves testing the time taken by the chamber to reach the specified temperature and humidity levels. The response time should be within the specified range.

Fourthly, the chamber should be tested for its safety. This involves testing the safety of the chamber in terms of power consumption, over-voltage protection, etc. This should be tested at different operating conditions.

Fifthly, the chamber should be tested for its environmental impact. This involves testing the chamber for its impact on the environment. This includes testing the effect of the chamber on air quality, noise levels, etc.

Finally, the chamber should be tested for its maintenance requirements. This involves testing the chamber for its maintenance requirements. This includes testing the chamber for the frequency of maintenance and the cost of maintenance.

Temperature and Humidity Test Chamber is for conditioning of samples prior to testing. It also can be used for a variety of materials of high - low temperature humidity test alternating test. Each operation procedure can carry out 9999 times or heaps of times cycle and repeated performance, and to the degree, divide further 5 segmentation sections to do part cycle of the extra.

The test method of a new system constant temperature and humidity chamber typically involves the following steps:

1. Connect power line to Miniature circuit breaker.

(L-Live wire; N-Neutral wire;PE-protective earthing conductor.)

2. Tum on. (On the back of thermo hygrostat chamber.)

3. Add pure water (12-13L) into tank. The water level shall be about 80.

5. Place specimens on holder, and close the door.

6. Press "POWER" button to enter Main Interface.

7. Set time, temperature and humidity. Click"START" to running.

8. When the set time is reached, take out the specimens. Close the door and power.

To conclude, the test method of the new system constant temperature and humidity chamber involves testing the performance, accuracy, response time, safety, environmental impact and maintenance requirements of the chamber. It is important to test the chamber properly to ensure the accuracy of the testing results.