About The Two Test Steps Of
Abrasion Resistance And Pilling Resistance For Martindale
The Martindale Abrasion and Pilling Tester is the standard method of determining the wear resistance of textiles or leather and the resistance to pilling.
Below are two testing steps for Martindale.
1.1 Test abrading table installation.
1.2 Put on the installed sample holder assembly on abrasion table and use 1pc of boltto fixed it. Place the weight(12Kpa or 9Kpa), according to the standard selection.
1.3 Position pin hole change.
1.4 Setting test cycles and speed that display on the left.
1.5 Click "TEST" to running.
1.6 When martindale fabric abrasion test machine reached test cycles, it will stop aautomatically, observe specimen.
2. Martindale Pilling Testing
2.1 Place pilling specimen holder on Abrasion table, then place 260g weight,close the top cover. Use 1pc bolt to fixed it.
2.2 Position pin hole change.
2.3 Setting test cycles and speed that display on the left.
2.4 Click "TEST" to running.